Ultra-clean filling machine

Common faults and treatment methods during the use of beverage filling machine

发布日期:2019-03-06 作者: 点击:

Glass bottle gas filling machines are widely used in food, medicine, and daily chemical industries. Drinking water filling production lines are produced in a variety of products. However, if there is a failure in production, the production belt will be given. Come and not underestimate the impact. Therefore, companies should learn more about what can happen in machinery and how to deal with it. The filling machine can be guaranteed to be more efficient, high quality and low cost.

        First, the filling volume of the filling machine is not allowed or not discharged, the treatment method:

        1. Whether the speed throttle valve and the filling interval throttle valve are closed, the throttle valve of the blowing and swirling integrated device cannot be closed;

         2. Is there any foreign matter in the fast-installing three-way control valve? If so, please arrange it. There is air in the leather tube of the three-way control valve and the filling head. If there is air, try to cut or sweep the air.

         3. Check if all seals are damaged. If there is damage, please replace them with new ones;

         4. Filling Whether the mouth of the mouth has a stuck appearance or delayed opening, if there is a jam, the valve core should be installed from the head. If the delay is opened, the thin cylinder throttle valve needs to be conditioned;

         5. The elastic force of the upper and lower tightening coil springs in the fast-installing three-way control valve will not open if the elastic force is too large;

         6. Is the filling speed too fast, adjust the filling speed throttle valve, and lower the filling speed;

         7. Can all the clamps and hose buckles be sealed, if any, please correct them;

         8. The magnetic switch is not loose. Please lock it after each adjustment.


 

Second, the filling machine material has the following reasons from the back end of the material tank:

        1. Is the material cylinder in the center of the material cylinder bracket? If the material cylinder has any change, please install it from the head;

        2. Is the piston and piston rod of the material cylinder fastened, if it is loose, please lock it;

        3. Material The cylinder piston O-ring is not damaged. If it is damaged, please replace it.

        Third, the filling machine cylinder piston does not come back after pushing the top of the movable magnetic switch position, press the emergency stop switch, adjust the active magnetic switch from the beginning.


本文网址:http://en.baotaite.com/news/386.html

关键词:Glassbottlegasfillingmachineprice,Beveragefillingmachine,Ultra-cleanfillingmachinemanufacturers

Recently browse: